Question on rod building
Page 1 of 1
Question on rod building
Im just a beginer at this and Im messing around with a project and for a rod tip has sizes 10-16 for the hole that goes over the tip was wondering if anyone knows the actual dimension of these sizes at all.
Re: Question on rod building
found my answer figure id put it on here for others know.
Tip tops are sized in 64ths of an inch, so a 4.5 tip top is 4.5/64 or .070". Here are the standard sizes and their equivalents. Please note that this does not refer to the diameter of the loop on the tip top, just the part that fits over the rod blank.
For reference 1mm = .0394" or 1" = 25.4mm
Tip tops are sized in 64ths of an inch, so a 4.5 tip top is 4.5/64 or .070". Here are the standard sizes and their equivalents. Please note that this does not refer to the diameter of the loop on the tip top, just the part that fits over the rod blank.
For reference 1mm = .0394" or 1" = 25.4mm
Similar topics
» Building a rod blank
» Building Problem.
» Building Funk
» Last of the Building Season
» ROD BUILDING MAN CAVE
» Building Problem.
» Building Funk
» Last of the Building Season
» ROD BUILDING MAN CAVE
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
1/29/2023, 9:52 pm by smitty
» Here is your new member from NJ.
7/18/2017, 6:43 am by mikejonson75012
» Greetings from the west coast.
7/18/2017, 6:42 am by mikejonson75012
» Newbie here
7/18/2017, 6:40 am by mikejonson75012
» Cooler Rack for front of truck
10/22/2016, 12:59 pm by Captain Ahab
» "Purple Heron"
8/10/2016, 11:41 pm by Captain Ahab
» Another Classic Conversion
3/16/2016, 1:44 pm by SALTYDOG
» A BAKERS DOZ !
3/15/2016, 9:04 am by SALTYDOG
» WINTERS OVER !
3/14/2016, 9:39 am by SALTYDOG
» Classic Conversion !
3/10/2016, 4:06 pm by SALTYDOG