E-Tex question

Completely non-fishing related project here.
We're working on a large (4x10ft) kitchen table for work. It's going to have a top made of hardwood floor with some large decals.
The plan is to use E-Tex as a "bar pour" finish.
Anyone have experience with E-Tex in this manner? Any pointers?

Eng5Lt wrote:Completely non-fishing related project here.
We're working on a large (4x10ft) kitchen table for work. It's going to have a top made of hardwood floor with some large decals.
The plan is to use E-Tex as a "bar pour" finish.
Anyone have experience with E-Tex in this manner? Any pointers?

Yes mix it well them mix it again and if you thinks its ready mix it again ....

When you mix etex it gets cloudy keep mixing untill it turns clear again then pour into another container and mix it again then pour it back into the first container and mix one last time...

Chris this sounds like a pain in the a$$ but if you dont mit it right the stuff will never harden....!!!

It will self level for sure and run off the edge unless you put something to stop that like tape...

Hope this helps you out ...

Thanks Ed.
There's a lot of time and cash in the project so we're just a tad nervous about doing the pour, since that's the final step and screwing that up could ruin the whole deal.
I'll throw up some pics when it's all done.